Swiffer Mount
Swiffer Mount
Created by: Hello Robot Inc
This tool allows a Swiffer duster to your Stretch. The designs uses a clamp to hold the Swiffer handle in place, allowing the height and orientation of the Swiffer to be adjusted by loosening the clamp.
Parts List
| Item | Qty | Vendor |
|---|---|---|
| M5x50mm BHCS | 3 | McMaster-Carr |
| M5 nut | 4 | McMaster-Carr |
| swiffer_mount.STL | 1 | PLA 3D printer |
| swiffer_mount_clamp.STL | 1 | PLA 3D printer |
| wrist_end_cap_5mm.STL | 1 | PLA 3D printer |
| Swiffer Sweeper Cleaner Dry and Wet Mop Kit | 1 | Amazon |
Assembly instructions
- Attach the M5 bolt through the swiffer_mount_primary part and lock into place by tightening the M5 nut
- Attach swiffer_mount_primary to the tool plate using the wrist_end_cap_5mm and a second M5 nut. Friction holds the assembly in place against the tool plate.
- Attach the swiffer_mount_clamp part using two M5 bolts and nuts, clamping the shaft of the Swiffer handle in place. Adjust the length and orientation of the Swiffer and clamp in place.
- Clean away!